Sensor Connector (for DSI 2 front Panel) Shadow 9 Specifications Sensing distance 3 mm

Specifications Sensing distance 3 mm +/-10% Set distance 0 to 2

This 12 mm diameter shielded inductive proximity sensor is one of the most useful general-purpose die protection sensors

at 500 VDC Dielectric strength 1

function display (red) Reverse display Supported

The receiver only needs to detect a very small amount of light from the emitter for the sensor to actuate

Sensor Connector (for DSI 2 front Panel) Shadow 9 Specifications Sensing distance 3 mmThe SV 40 Male connector is used when you want to connect an individual sensor to the DSI 2 front panel. These connectors should be soldered to the sensor cable end. The sensor wiring is as follows: Pin #1 +24V Sensor Power (Brown wire) Pin #2 Power Return Ground (Blue wire) Pin #3 Sensor Signal Wire (Black or white wire)